Three way Strat wiring....

[Dr. Jimmy]

Hi, I want to wire up a Strat using two cool rails pickups in the neck and bridge position (nothing in the middle)with a three way switch, volume pot, neck tone and bridge tone. How can I accomplish this and have the tone controls act independantly from each other?

I'd like to be able to have the switch in the middle position (both pickups on) and be able to have the bridge tone full up and the neck tone rolled off.

Any ideas/diagrams????

Thanks!!!

[Benjy_26]

Just adapt the JV/EJ strat wiring to a tele's three way switch.

[ErikH]

This diagram for that setup, but in the middle position, I don't think you'll get the fully independent tone control behavior you're talking about, but you might the more I look at it. Give it a shot.

http://www.seymourduncan.com/support...ic=2h_1v_2t_3w


3-way switch translation.

http://www.seymourduncan.com/support...atic=3ws_trans

[Dr. Jimmy]

This diagram for that setup, but in the middle position, I don't think you'll get the fully independent tone control behavior you're talking about, but you might the more I look at it. Give it a shot.

http://www.seymourduncan.com/support...ic=2h_1v_2t_3w


3-way switch translation.

http://www.seymourduncan.com/support...atic=3ws_trans

Awesome!!! Thanks!