I'm in the middle of a pickup swap and...

[12guitdown]

...and I'm currently about half way through and decided to test it. btw, it's a 335 so I want to make sure it's right before shoving everything back through the F hole. I tested the bridge side and when rolling the vol pot back to about 8.5, I have about about 5-10% of the vol left.
Did I fry the pot maybe?
Vol is 550k cts, tone is 250k push/pull, .o22 orange drop, push/pul is to split the coil parallel but I flipped the black with green and the red with white so the slug side will be activated when pulled.

Here's the scheme I'm using,
http://www.seymourduncan.com/support...ic=2h2v2t3w2sp

Maybe someone can tell me something while I double check everything again.

Thanks,
G

[12guitdown]

I also noticed when the PP is pulled, I still get sounds when I touch the bobbins and slugs with a screwdriver. Hmmmm....