I was wondering about a particular question about the s1 wiring on Fender Strats with SCN or any other stacked pickups.
Say the lower part of the bridge bobin measures x ohms, and the upper y. Similarly, x' ohms for the lower part of the middle pickup bobin and y' for the upper part.
When the s1 is set to middle/bridge series position, is the total ohm x+y+x'+y' ? That is is all parts of the two bobins connected series? Or is it x + x' (I assume that still those suckers are RWRP, which might not very well be)? That is is only one part of one bobin connected in series with one part of the other bobin?
Actually the same question applies to the middle neck series connection as well.
I don't have any deluxes, so cannot do the measuring with a multimeter (via a cable connected to the jack, instead of opening it up).