P-Rails wiring

[Mark Le Comte]

Hi, hopefully a very easy question. I am installing P-Rails into my semi hollow and the cavity is too thin to allow me to use push pulls pots for the tone pots, I can just fit them in for the volume pots though. Do I just wire this as per the standard wiring diagram except the put the extra six attachment points on the volume pots and leave everything else the same?

[MikeS]

Wire the 3 terminals on the pot per the diagram. It does not matter which pot the push/pull is on, as the two, while physically on the same device, act independently of each other.

[Sludgenutz]

Hi, hopefully a very easy question. I am installing P-Rails into my semi hollow and the cavity is too thin to allow me to use push pulls pots for the tone pots, I can just fit them in for the volume pots though. Do I just wire this as per the standard wiring diagram except the put the extra six attachment points on the volume pots and leave everything else the same?

By how you are describing it, and my understanding, Yes!