P-Rails P90/Rail Wiring Help
I have a G&L ASAT Bluesboy and would like to replace the neck Seth Lover with a P-Rail. I'd like to replace the tone control with a push/pull pot that would give the P90 in the down position and just the rail in the up position. Is this possible? Thanks.
Re: P-Rails P90/Rail Wiring Help
For this all you would have to do would be to solder the red and white wires together and connect them to the middle lug of the switch. Then connect the top lug to ground and the bottom lug the hot signal. You don't need the other side of the switch.
2000 Gibson Les Paul Special / 2001 Epiphone Dot (SD '59 Neck and SD '59/Custom 5 Hybrid Bridge) / 70s Vantage Double Cutaway - SD P-Rails / Home-made Mahogany Project Guitar with P90s / National Lap Steel - SD Screamin Demon / 1972 Fender Princeton (Weber Blue Pup speaker) / 1979 Fender Champ / 1960s Silvertone 1483 (Weber 10F150 & 10F150T speakers) / Silvertone 1481
facebook.com/stationaudio
Re: P-Rails P90/Rail Wiring Help
Originally Posted by lyongraulty
Thank you - I hope to have time for this project next week.
Re: P-Rails P90/Rail Wiring Help
Finally getting time to think about this again. Before going throught the work of replacing the existing pot with a push/pull I'd like to first wire it to the existing pot as a P90 only. Any advice on this?
Re: P-Rails P90/Rail Wiring Help
I have a flying V with 1V - 2T and 3 way switch [standard]. I'm switching to P-Rails and want to incorporate 2 mini toggles to get the max tone out of the pickups. Anyone have a schematic they could send me? I would greatly - greatly appreciate it. Also wrote to Seymour to see if they could whip something up as well.
Posting Permissions
Reply With Quote