Super 5-Way Switch and Tapped Tele

[mrturtle_91]

So I was thinking of getting a super 5-way switch for my Tele to wire it for coil splits, my bridge pickup is a tapped quarter pound. If I use this diagram and use the tap wire where the red and white humbucker wires go to, will that tap the pickup in the second position, or will it not work?

[ehdwuld]

I would think that is how that works

[DMyers77]

So I was thinking of getting a super 5-way switch for my Tele to wire it for coil splits, my bridge pickup is a tapped quarter pound. If I use this diagram and use the tap wire where the red and white humbucker wires go to, will that tap the pickup in the second position, or will it not work?

No, if you wire it like that, you will ground ground the tap wire in the #2 and #4 positions.... You don't want that. You want to use the tap wire instead of the normal hot wire.

I can draw up a diagram for you, if you tell me more about your guitar and what you want each position to do.

Or, if you just have the tapped bridge pickup, you can use this diagram with a normal 5-way switch:

http://www.seymourduncan.com/support...pped_tele_5way

You'll get:

1 - bridge (full)
2 - bridge (full) and neck
3 - neck
4 - bridge (tapped) and neck
5 - bridge (tapped)

[ehdwuld]

No, if you wire it like that, you will ground ground the tap wire in the #2 and #4 positions.... You don't want that. You want to use the tap wire instead of the normal hot wire.

I can draw up a diagram for you, if you tell me more about your guitar and what you want each position to do.

Or, if you just have the tapped bridge pickup, you can use this diagram with a normal 5-way switch:

http://www.seymourduncan.com/support...pped_tele_5way

You'll get:

1 - bridge (full)
2 - bridge (full) and neck
3 - neck
4 - bridge (tapped) and neck
5 - bridge (tapped)

wait a min
simply replacing the ground on the right side of the the diagram
---- the dotted lines -----
performs that task

no need to reinvent anything

try it one way if you don't like it move the grounded end of the wire to the
volume pot

easy peasy

[DMyers77]

wait a min
simply replacing the ground on the right side of the the diagram
---- the dotted lines -----
performs that task

I didn't see that when I first glanced at that diagram.

[ehdwuld]

yea I didnt notice it either till someone pointed it out to me last month