Has anyone used the Q Filter with a Bill Lawrence L500XL?

[presa_tito]

Right now I have this pickup in the bridge and only have a vol. control. I'm going to drill another hole to put a tone contol in as well. I'm just curious about this q filter though. If I install it, it will always have to be on and take over the tone control. So I am wondering if anyone likes it. It is supposed to create great tonal variation.
Thanks.

[jeremy]

im not sure what q filter you are talking about.
got a link?

[MattPete]

http://www.billlawrence.com/Pages/Pi...w/Q-Filter.htm

[ArtieToo]

Here's a thread that gives a little more info as to what it is, and how its used.

http://p082.ezboard.com/fguitarsbyfe...art=21&stop=40

“The Q-Filter is an LCR network - a 1 henry, low Q noisefree inductor in series with a .02 micro farad cap in parallel with an 8 kilo ohm resistor. Wired like a cap to a tone pot, you can gradually decrease the impedance of the circuit but maintaining a slightly higher impedance below 1100 Hertz. Also available without the cap and the resistor to gradually decrease the impedance of the pickup.”

[presa_tito]

I've read the technical description and was just seeing if people thought it was a good addition.