Wiring the AHB-2 Jumper to Push-pull

[stuntmedia]

I just received an AHB-2 Blackouts bridge humbucker, with the intention of wiring it to a push/pull pot, as it says on the Duncan website product description. However, I am unable to find a wiring diagram of this mod, and it is not clear from looking at the pickup, either. Has anyone done this mod, or know how it would be accomplished. I have the necessary 25k push/pull pot, and I'm ready to roll, I'm just not clear on how to do it. Any help would be appreciated.

Thanks,
PW

[mustaine-who?]

I wired mine to a mini-switch...

[stuntmedia]

How is is physically wired? Where are your connections?

[xntrick]

i also had mine wired to a mini switch, i used a connector from an old fan assembly i had lying around...

[stuntmedia]

Not to offend either one of you guys who were kind enough to reply, In fact, thanks very much, but this isn't giving me much to go on. Mini-switch or push/pull, what am I connecting to on the pickup? Where does the funky plastic jumper go? I wish, if Duncan is going to say that this is an option, that they would post a diagram on their site, or ship it with the pickup.

[xntrick]

the jumper goes on the the 2 pins underneath the pickup..the switch and harness can be seen in this photo on the left hand side: