Results 1 to 4 of 4

Thread: Bridge out of phase with a bypass push/pull

  1. #1
    hemmi
    Guest

    Smile Bridge out of phase with a bypass push/pull

    I have a question regarding out of phase mods. can you put the bridge out of phase insted of the neck (i have a 59 sh01 neck pickup and a jb sh04 bridge).
    the bridge is a 4 conductor and the neck is a single conductor.
    so i want to know if that would work.

    i also saw this bridge bypass on the 2012 lp std. so basicly if you pull the bridge tone up the circut gets bypassed and the bridge output is the only thing that goes out at 100%volume and 100%tone.

    any help would be greatly appreciated

  2. #2
    Slutbucker Pimpologist ArtieToo's Avatar
    Join Date
    Mar 2004
    Location
    Jacksonville, FL
    Age
    63
    Posts
    17,411
    Likes (Given)
    28
    Likes (Received)
    1173

    Default Re: Bridge out of phase with a bypass push/pull

    Welcome to the forum.

    What you want is pretty straightforward:
    Many people seem to end up defining their entire life by the work that they keep. They have no hobbies, are part of no meaningful social groups, and have few friends outside of work. After enough time spent like this, they seem to get to a mental place where they are incapable of escaping. After several decades in captivity, trying to release an animal back into the wild usually doesn't end all that well for the animal. It's very sad. GuitarStv

  3. #3
    hemmi
    Guest

    Default Re: Bridge out of phase with a bypass push/pull

    thank you.

  4. #4
    hemmi
    Guest

    Default Re: Bridge out of phase with a bypass push/pull

    i actualy did some moar digging online and found this on the seymour duncan website. http://www.seymourduncan.com/support...itching_for_hb

    the output from there would go through another push pull which would direct it either out (bypass the circut) or into the volume pot (and be either in or out of phase)

    i got the bypass figured out

    bridge out O - O output in (output from the 3 way switch)
    ...bridge in O - O output out
    empty one O - O bridge in (connected by wire to the other bridge in to be able to connect to output out )

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •