Wiring Diagram for SHR-1 , SVR-1, SCR-1 , Push/Pull

[nmorales30]

Hi, I’m replacing the pick ups of my Fender American Std, I’m going to install this: Bridge: SHR-1 / Mid: SVR-1 / Neck: SCR-1

I’m going to replace the volumen pot for a push/pull.

The SVR-1 wiring diagram is different than SHR-1 and SCR-1, and there is nor diagram for push/pull.

If I want to Split the SVR-1, can I install It in the same way than a SHR-1 and SCR-1?.

[GregJr]

Don't split the SVR, you'll only have the top 3 or bottom 3 strings working depending on the split coil. I have a set of 3 SVR's that are wired in series/parallel with a push/pull. If you're installing the SVR in the middle position, i suggest you wire it series. Your 2 other pu's are hotter than the SVR and wiring it in parallel will yield a lower output in relation to the others.Wire it in series and you'll get a higher output.

[nmorales30]

Can I install the SHR-1 and the SCR-1 in the same Push/Pull pot?

[cohibacris]

You can, but have you considered a super switch instead? With the P/P you'll only have access to one at a time, whereas if you have a standard 5 position switch or a 3 position, the super switch would be my choice.

[cohibacris]

I made an assumption you want the SVR in one position and the SHR1 in the other, is that right?

If you're going to just have the two constant on, it will work (still limited flexibility & original answer stands, but I thought I'd qualify...)