500K/250K Anyone Try This ?

[crunchman]

500K on 1 & 2 would be great.Even though I don't demand a #2 position in an
H-S-S arrangement (havent heard a good one that sounds even like the normal two single coils out of phase) anyway, yes that would be great. 250K for #3-4-5 !

[jumble jumble]

Ok. I'll be able to do that for you in about 20 hours time, is that OK?

[shawnlanefan]

Pls post that, I'd like to see that too, thanks

[crunchman]

no rush jumble, solid for the favor ! I still have to order a switch too.

[jumble jumble]

Here you go:



Trouble is, I've done this quite late at night. I'm pretty sure this will work, but at the same time I think it could be simplified.

Don't start soldering until someone else (ie Artie) has been in the thread and had a look!

I've used lots of different colour wires there. The really pale blue represents white wires, but the other colours of wires that aren't connected to pickups are just like that so that the diagram is a bit easier to follow.

EDIT: updated to fix mistake (do a hard refresh on the page to see it). I also recommend some heatshrink on the legs of the capacitor.

[crunchman]

WOW ! Nice doc. I will order a switch & await the Q.C. man !

Effort is greatly appreciated !!, what program ? I would like to start

doing amp layouts.

[jumble jumble]

Haha, I've immediately spotted a problem with it having woken up this morning! Will get it fixed ASAP.

EDIT: fixed in original post.



I used Visio to do the diagrams, and some stencils I downloaded from TDPRI.

[jumble jumble]

Thinking about it, although it looks fine on the diagram, you might not want to use the capacitor to go from the switch to the tone pot, if it's a longish way. If the legs reach then great, so long as you heatshrink them. If not, just take a wire from the switch to the pot, and put the capacitor between the middle lug of the pot and the pot casing.

[jumble jumble]

This is the version with those recommendations done. I think this is probably a better version.

[crunchman]

jumble, was wondering if this diagram is "good to go" ? Whada ya think ?