MIM Strat parts for sale

[ItsaBass]

MIM Strat parts, 2005:

- Tuners. Sealed, F on the back, and two locating pins. High E tuner has a deep scrape. Others have some cosmetic blemishes. But they look good over all. They are not rusty, and they work as new. Asking $25 shipped.

- Complete stock wiring harness, with jack. Ready to drop right in to any Strat once you provide the pickup screws. (Springs are included, though.) I had to remove the jack and unhook the ground wire, but no other solders have been touched. No knobs or switch tip. Switch screws are actually black Kramer screws. Good switch, and full-sized CTS pots. Choose between well used white pickup covers or barely used parchment covers. If you take the parchment covers, I'll also include a set of matching knobs. Asking $45 shipped.

- Synchronized vibrato, 100% stock. Bridge, saddles, skinny "wedge" block, three springs, claw, claw screws, six bridge mounting screws, and vibrato arm. Some rust on the lower saddles, but only a few small spots. Saddles still adjust as intended. The plastic tip for the arm has been a bit chewed up by one of my cats. Asking $20 shipped.

- If you want the whole lot of stuff (tuners, harness, vibrato), I am asking $85 shipped.

I'll consider offers and trades.

Thanks!

P.S. I also have nine Strat pickup covers and three sets of Strat knobs for sale. Two sets are MIJ parchment, and the other set is Custom Shop parchment, which is a harder and very slightly translucent plastic. For three pickup covers and three knobs, I'd like $12 for each MIJ set and $17 for the CS set. (Prices include shipping.)

I also have an 11-hole anodized guard for Strat, mildly used. Asking $30 shipped.

[ItsaBass]

bump

[ItsaBass]

bump

[ItsaBass]

bump