I'm refurbing my old strat at the moment and have a question about how to wire the complicated electronics I'm hoping to put in. I'm hoping for...
Graphtech Ghost bridge saddles (without hexpander but with acousti-phonic preamp)
BRIDGE : Seymour Duncan Hot Rails
MID : EMG S-X
NECK Seymour Duncan Cool Rails
As for controls
I would like to have the first (furthest up pot) to be a volume control for the two Seymour Duncans, which when pulled coil splits both.
The mid pot to control the EMG volume, but when pulled it adds distortion to all the pickups / to the output, or a sort of on board effect.
The bottom pot to control the Ghost volume, and when pulled acts as a kill switch for the Ghost only.
I'm just wiring the standard 5 way selector switch setup with nothing special there
I do have an idea as to how this should be wired and have drawn out a bit but do not know exactly how it should be done, I know this is a complex idea but I would really like for it to be done, any help with this would be appreciated, I'm not sure where to start, thanks