assembling tips

[WITH FULL DISTORTION]

Hey guys
how are you?!?!?!
im back again ahahah after a big abssence time.
i have a question as well
i sent both my charvel and fender(2 bolt on guitars with neckplate) to be repaired at a tech and now i received them BACK.
what i want to know is this : do i need any special tip or tool or machine to assemble back the neck into the body?
or is it just "plug and play" ???
Q: )
Thanks
JP

[Aceman]

HAILS JP!!!!!!!

A simple Phillips head screwdriver should do it.

[WITH FULL DISTORTION]

Fking hails back man
ahahahaha thanks for the help
i just Spotted one tricky thing in my charvel
2 of the 4 screws that join the neck into the body ARE smaller than the other two.
So 2 longer and 2 shorter.
WHERE should i screw the shorter ones and where should i screw the larger ones?
Q: ((((
My guess is that the longer ones goes on the bottom part and the shorter ones on the upper part

[GuitarDoc]

longer ones toward the head, shorter ones toward the tail.

[WITH FULL DISTORTION]

head=neck?
tail=body??

[Jocelyn]

head=neck?
tail=body??

YUP. Good to see you back. I had taken a long break too.

[WITH FULL DISTORTION]

i bought an Ibanez sr505 bass . made in korea. Q: )
and ill soon put some questions about a bass amp. i dont know NOTHING about basses. this is my FIRST Bass EVER.
So, ill need help choosing it.

[WITH FULL DISTORTION]

longer ones toward the head, shorter ones toward the tail.

hey man ... longer screws on the first 2 holes on the neck side of the neck plate and the shorter ones on the body side of the neck plate or THE OPPOSITE?
q: )

[PonyKiller]

Be careful with that, a mistake could result in a screw coming out of the fretboard!

Maybe try putting all screws thru the neckplate and body BUT with the neck off. If everything seems leveled, then it's OK. If one or two seem higher or lower just swap them and put the neck side to side to check if no screw can go all the way thru it.

An Ibanez RG570 I had had an odd pattern, like:
Looking the guitar from the back, neck to the left, trem cavity on the right.
long ------- long
...short ---- short

I just fiddled with them until everything was leveled.

EDIT: By leveled I mean the tip of the screws.

[WITH FULL DISTORTION]

****ing thanks man
im still confused. ahahahah

[GuitarDoc]

None of the screws that came out of it will go through the fretboard.

Just put them in, in any random order/place. If you get one screw that becomes very difficult to screw and it's not quite all the way down, then put that screw in another hole...that hole requires one of the shorter screws.

[WITH FULL DISTORTION]

Assembling process done
thanksa guys
Q: )