I was just wiring my Les Paul to the Seymour Duncan (2 HMBK/2 VOL/2 TONE/ 3- way switch with series-split-parallel) schematic.
I decided that I wanted to have the option on BOTH humbuckers, SO, I took (2) DPDT's and wired it the way it suggests with the bridge pickup. I took the white wire to lug B on both switchs. Then took the red wire to lug E. Then the green to lug C and the Black to lug F. Then, from both Lug F's, I went to Lug 3 on the volume pots. Then from lug 3 to lug 2 with caps on the tone pot. I took the grounds from lug 1, and attached them to the middle of the ground plate with the ground lug. I attached the ground from the pickups here too. NOW, I am confuzed with the output jack/toggle switch. I took the red wire from lug 2 on the TREBLE VOL, and went to the toggle. I took the white wire from lug 2 on the neck vol, and took it to the toggle. I then took the black wire from the toggle to the common ground, and attached the green and the output jack.
All I get is hum, no signal.
I need immediate help, I need my guitar for tomorrow.