View All | 1 | 2 | Next Page
  • This mod shows how to split 3 single-coil sized humbuckers using one push/pull pot. You can change from 3-humbuckers to 3-singles by flipping a switch.
  • We know....you went to install your brand new Seymour Duncan pickup, and the wiring instructions tell you how to connect everything---BUT---the wire colors of your stock pickups look the same but are located in completely different places than our wiring instructions indicate.
  • Basslines® bass pickups range from the most authentic vintage reproductions to the most modern active pickups. This Tech Tip looks at installation of active pickups. These include: "Phase I" soapbars (replacements for Bartolini® P-2 and...
  • There comes a time in every Tele® player's life when you try to find the right sound for the middle position on your three way switch. One of the questions asked is: How do I change...
  • We asked "Bendmaster of the Telecaster" Jerry Donahue to share some of his secrets for setting up a Telecaster® bridge and keeping it properly intonated (Jerry demonstrates this technique in his clinics). Attention all current and would-be Tele® slingers!...
  • Here's a quick test to determine if your potentiometers need to be replaced or just cleaned. With the guitar plugged in, try turning the scratchy pot back and forth quickly a few times. If the scratchiness starts to lessen,...
  • A humbucker is split when only one coil is engaged full output. This is often used to achieve a single coil sound from a humbucker. Here's one of easiest and most controllable ways to split a...
  • This diagram uses a push/pull to turn on the bridge pickup IN ADDITION TO whatever is selected by the 5-way switch.
View All | 1 | 2 | Next Page