The Antiquity vintage Jazzmaster single coil pickups use calibrated alnico 2 rod magnets and a custom coil wind to give you that classic Ventures tone.
DCR – Short for DC Resistance, is measured in Ohms and is the total resistance of the copper wire wound around a coil form. The length of the coil form, the number of turns and the gauge of wire all affect the DCR reading. DCR is often used as a gauge of output because as the turns increase, so does the output, though magnet type and the coil geometry also influence output. Magnet – We use several different magnet formulations: Alnico 2, Alnico 3, Alnico 4, Alnico 5, Alnico 6, Alnico 8 and Ceramic 5/8. In the case of pickups, the most significant characteristic is the gauss strength, which is a measure of the density of the magnetic field. Of the magnets we use, Alnico 3 has the lowest gauss strength. From there in order of ascending strength you have A2, A4, A5, A6, Ceramic and A8. As the gauss strength goes up, so does the output. The magnets at the lower end of the scale tend to produce a softer attack and a degree of “bloom” to the envelope of the note.
Ceramic magnets should be considered as an individual case because they do not contain any nickel or iron. This has the effect of decreasing the inductance of the pickup and significantly raising the resonant frequency. It is for this reason that many consider ceramic magnets to have a brittle sound, not their gauss strength. Looking at this from another point of view, ceramic magnets can be said to produce increased clarity, better note definition and faster response to picking. Output – The overall output of a passive pickup is influenced by several design factors: number of turns of wire on the coil(s), strength of the magnet, coil geometry and magnetic circuit geometry.The output of an active pickup is influenced by the same factors but is predominantly determined by the design of the onboard preamp.
The late 50s Jazzmaster pickups used wide, flat coils that produced a deep, rich tone that Fender hoped would appeal to Jazz players. While it did, it also became the go-to instrument for so many of the instrumental bands of the 60s. And, it turns out, the Jazzmaster is also a monster when turned up and played through a fuzz pedal.
The Antiquity Jazzmaster pickups are outfitted with calibrated alnico 2 poles, and a custom coil wind to soften the treble attack for a sweeter, smokier overall tone. The treble response has snap and sparkle, but is not harsh, while the bass response is nice and tight. The Antiquity Jazzmaster neck pickup is reverse wound, reverse polarity so that, when used together with the bridge, the pickups will be hum-canceling.
The Antiquity Jazzmasters are drop-in replacements for any Fender American Standard sized Jazzmaster pickup and will fit nicely into the existing cover. Hand built in our Custom Shop, the Antiquity vintage Jazzmaster single coil pickups use alnico 2 rod magnets, a custom coil wind with heavy formvar mag wire, vintage-correct flatwork, cloth push-back lead wire, and they are all lacquered and wax potted like the originals.
The E.Q. chart gives you a general idea as to the bass, mids and treble of each pickup position
Neck
B
M
T
Bridge
B
M
T
Hand Built in California. Period Correct. Every Time.
Our team of master builders have been with us for an average of 21 years—they take pride in crafting our products to create the most amazing sound possible.
Take Your Tone For A Test Drive
If you’re not 100% pleased with the sound of your Seymour Duncan pickups, you can exchange them for up to 21 days after purchase. This offer applies to any pickups bought from an authorized Seymour Duncan dealer in the USA.