DCR – Short for DC Resistance, is measured in Ohms and is the total resistance of the copper wire wound around a coil form. The length of the coil form, the number of turns and the gauge of wire all affect the DCR reading. DCR is often used as a gauge of output because as the turns increase, so does the output, though magnet type and the coil geometry also influence output. Magnet – We use several different magnet formulations: Alnico 2, Alnico 3, Alnico 4, Alnico 5, Alnico 6, Alnico 8 and Ceramic 5/8. In the case of pickups, the most significant characteristic is the gauss strength, which is a measure of the density of the magnetic field. Of the magnets we use, Alnico 3 has the lowest gauss strength. From there in order of ascending strength you have A2, A4, A5, A6, Ceramic and A8. As the gauss strength goes up, so does the output. The magnets at the lower end of the scale tend to produce a softer attack and a degree of “bloom” to the envelope of the note.
Ceramic magnets should be considered as an individual case because they do not contain any nickel or iron. This has the effect of decreasing the inductance of the pickup and significantly raising the resonant frequency. It is for this reason that many consider ceramic magnets to have a brittle sound, not their gauss strength. Looking at this from another point of view, ceramic magnets can be said to produce increased clarity, better note definition and faster response to picking. Output – The overall output of a passive pickup is influenced by several design factors: number of turns of wire on the coil(s), strength of the magnet, coil geometry and magnetic circuit geometry.The output of an active pickup is influenced by the same factors but is predominantly determined by the design of the onboard preamp.
Like a classic car, sometimes stock just isn’t good enough. When you love the classic curves but need more horsepower under the hood, that’s where the Psyclone Hot set comes in.
The Seymour Duncan Psyclone Hot pickups take the distinctive sound of the original Filter’Tron pickups and supercharges it. Punchy mid-range, tight low-end, and smooth treble combine with the higher output to deliver a pickup perfect for rock, new wave, punk, and psychobilly.Originally designed in our Custom Shop, we took special care when sourcing materials to ensure the look and fit of the pickups are perfect – whether you’re hot-rodding a vintage guitar or dropping them in a modern classic.
The Psyclone Hot pickups are drop-in replacements for any guitar routed for Filter’Tron style pickups and includes the correct hardware for either direct mount or pickup-ring mounting options. The neck pickup features a lower output wind that retains clarity and balances the output, while the bridge pickup is hotter and punchier.
Psyclone pickups are hum-cancelling and use single conductor lead wire. Each Psyclone pickup is handmade in Santa Barbara, CA.
The E.Q. chart gives you a general idea as to the bass, mids and treble of each pickup position
Neck
B
M
T
Bridge
B
M
T
Hand Built in California. Period Correct. Every Time.
Our team of master builders have been with us for an average of 21 years—they take pride in crafting our products to create the most amazing sound possible.
Take Your Tone For A Test Drive
If you’re not 100% pleased with the sound of your Seymour Duncan pickups, you can exchange them for up to 21 days after purchase. This offer applies to any pickups bought from an authorized Seymour Duncan dealer in the USA.